Fuzeblock switchable fuse panel

This is a very simple to install switchable fuse unit to allow installations of any accessories, either switched. The Nippy Normans box and the other kit looks rather pricey for some bits you could get from Maplin. Modern motorcycling often involves adding countless extra electrical gadgets to your bike for heating and navigation, or welding an old spotlight on the front of your. The fuzeblock mounts with some sticky pads, i used some that were for sticking on a car numberplate, and it has enough room for the seat to go on.

The FZ-boasts a few incredible features. For instance, it can switch on or off based on whether the bike is running or it can supply constant power.

It also makes all your accessories Can-Bus-friendly. Great value switch panel with switches, fuse block and fuses. Includes switch labels which can be used if required. Image for illustration purposes. Used: An item that has been previously used.

The item may have some signs of cosmetic wear, but is fully operational and functions as intended. On a piece of paper, write down the Accessory device, what value of fuse it will nee and whether power needs to be available to it all the time, or only when the motorcycle is running. If so, are they worth the £Nippy Normans asking for and what did you use as.

I used an inline fuse with a relay. One thing about the task was the amazing job that honda have done on putting anyone off ever wanting to take off the panels. One Side only was at least 2hr. Be sure to use the braiding including for the wiring harness as much as possible to protect the wiring from rubbing against an. This Pin was discovered by Tony Harrison.

Discover (and save) your own Pins on Pinterest. I took mine off the mains fuse only live after ignition on. Jaws Corporal CockUp Staff Member. If you are using just 5v then even a cheapo type 12v to USB. INNOVV PowerHubPower Distribution System Kit for Motorcycle.

Looking for Blade Fuse Box ? Im not sure yet what I would need to power with ignition off but i would rather have the option than not if the need arises. I have come up with the following, using a switch. Easy to install and compact (it measures just x x cm) the FZ-allows multiple devices to be attached to a 12-volt motorcycle electrical system without messy, complicated wiring set-ups. Can change from switched to permanent in s. Dashcam location and wiring problems. I still have to find a switchable power source but I might be able to get it from the redundant fog lamp cable sitting idle under the fairing without any need for splicing or.

Fuzeblock switchable fuse panel (FUZ-FZ1) - Nippy Normans.

There is a great deal of circut board exposed on the back and it seems to far from weatherproof. Has anyone had experience with fuse panels and the canbus-friendly charger? Dirt simple, in that regard.

They also seem more water-resistant than the Centechs.