Immersion heater fused spur

Find great deals on eBay for fused spur switch immersion. Also, a 3kW immersion heater is pulling up to 13A over an extended period. Sockets are not designed to carry that level of current for extended periods and will burn out. A local pub football has asked me to wire up the new immersion heater with is switched from a fused spur unit, would a 1. Immersion Heater Fed From Ring Final Circuit. IET Forums - Fused Connection Units to 3kW.

I am planning to install a pump which will power two showers. The most convenient place to site the pump is in the airing cupboard. A DP fused switch unit but said they dont do them ? I realise a lot of power is used to heat the water but is this normal?

If not, what might cause it? Order online at Screwfix. Combined timer and fused spur ideal for control of towel rails, panel heaters , immersion heaters and fan heaters.

Is there anyway I could replace. Timeguard FST11A SupplyMaster Hour Fused Spur Timeswitch,Digital time control for immersion heaters , storage heaters , convector heaters , water. TGBTis a boost timer for immersion and room heaters. Timeguard DP Fused Switched Spur with Digital TimerDay Timer (ON OFF Programs per day)Permanent OFF and timed outputs available. Self-cancelling override.

Integral memory back up battery retains programmes in event of power failure. Spur off to another fused spur with a 3-amp fuse. After all if the immersion heater is fed on a 2. Ideal for switching lighting and electrical heaters. The Electrical Counter offer over 40electrical products lower than trade price, ready and available in stock for delivery throughout the UK. It is suitable to use with up to 3kW immersion heaters.

If you really want to keep the second one then fit a 13A fused spur. The boiler rating is irrelevant. It needs a 3A supply for the internal electrics, nothing to do with the immersion heaters. The FSTfrom Timeguard is a fused spur electronic programmable day timer. It is a general purpose timer suitable not only for controlling immersion heaters up to.

Suitable for use with up to 3kW immersion heaters. Switches the following lighting loads: 750W incandescent or halogen lighting, 500W fluorescent lighting, 100W compact fluorescent lighting (cfl’s) and 200W LED lighting. Secondly, the immersion heater is wired directly into a fused switch inside the cupboard. I assume (from the instructions) that the time controller should be wired between the heater and the fused switch inside the cupboard?

Low Prices on Top DIY Brands. This timer spur will control either your heating or lighting with an easy viewable electronic day programmable control interface. Wi-Fi enabled control for all manner of electrical applications connected to Timeguard’s FSTWi-Fi 13A Fused Spur Timeswitch.

The Timeguard Hour Fused Spur Timeswitch is a digital time control for immersion heaters , storage heaters , convector. Whether a light switch or a fuse holder. WiFi enabled control for all manner of electrical applications connected to Timeguard’s FSTWiFi 13A Fused Spur Timeswitch.